Fieldmaster Solar Energizer - Fence Guard E3
Brand: Fieldmaster Solar Fencing
Categories: Solar Products, Solar Zatka - Fence Guard, Solar Zatka - Fence Guard,
Availability: In Stock
Cash on delivery Availability: NO
Price:
Rs 13,000.00
Qty:
Fieldmaster Solar Energizer - Fence Guard E3
Area covered: Approx. 2000 meter or 50 vigha (1 Vigha = 25000 Sq.feet).Technical specification:
Output energy | 3 J factory Set |
Output Voltage | 6 to 9 KV, selectable model |
Output current | 7A |
Pulse Interval | 1.2 second nominal |
Pulse Duration | 200 micro second, nominal |
HV output | 9000 V 1 zone |
LV output | 6000V 1 Zones |
Input Power | 12 V DC |
Input current | 250ma |
INDICATOR LIGHTS (LEDs) | |
Green LED: POWER ON | Flashes for fence energizer on |
Red LED: Pulse | Fence voltage ok when LED Blinking |
Red LED: Fence fault | Fence is temper, short, low voltage, ground, When solid on, indicates that the high voltage pulse is lower than the adjustable set point voltage, and your fence requires maintenance. The low voltage indicates that the high voltage pulse has dropped below effective levels (200 volts) and immediate action should be taken to preserve the effectiveness of your perimeter fence (alert condition – alarm). Clearing the grass and weeds from the fence usually clears this indication (weed alert alarm). |
Red LED: Battery low | when battery reach 12V |
Red LED: Battery discharge | when batter doesn’t have voltage to run |
Green LED: Charging | when solar Panel connect or charging going on |
OPERATION |
|
Smart high voltage sensor | Takes an electric fence charger pulse and analyzes it for peak voltage, pulse width and period. The Fieldmaster fence energizer can accurately measure voltage pulses from almost any fence charger or pulse source, including the spark plug voltage on a gasoline engine. The design algorithm used in this device was determined for stability, longevity, and reliability under a wide set of usage parameters. (Patents pending.) |
Programmable siren and indication system | The red light will flash for every pulse that is higher than the set point level. |
Maintenance voltage | The maintenance threshold voltage is set at 6 KV at the factory and is user-adjustable. The “maintenance set-point voltage” is usually set about 1 KV to 2 KV less than the fence energizer output. |
Weed alert | Then creeping weed growth will be noticed before the fence voltage drops below an effective level. This maintenance voltage is adjustable from 1.5 KV to 8 KV. If flora (grass, bushes, limbs and leaves) partially load or partially short out the high voltage and reduce the effective pulse voltage to below the adjustable maintenance level voltage set point, then the yellow LED will light and the maintenance contacts will close. |
Voltage accepting/maintaining | Can measure voltage by varying sensitivity setting and also can check your insulated quality your fence voltage . |
False alarm setting | The maintenance function has approximately a 100 second delay, to avoid false alarms. |
Automatic reset | If the grass or limb is blown off or removed and the charger pulse voltage is restored, then the maintenance alarm will reset itself and the maintenance contacts will open. When the pulse voltage drops or becomes less than 200 volts, the “no voltage” contacts will close. There is a built-in delay of 3 seconds before the red LED will light and the alarm contact closes, This device is designed for long life with ease and consistency of operation. |
Note: The product offer price may vary so kindly confirm the latest price with us before buying the product.
Manufactured, Packed & Dispatched by: Fieldmaster Solar Power Fencing
Click here to see Guarantee / Warranty of this Product.